Comparison of Amnion Chorion Membrane vs. Dense Polytetrafluoroethylene Membrane in Ridge Preservation Procedures

NCT02602223 | Completed Phase 2 Results

• 1 other identifier: 1207009182
• Study Type: interventional
• Target: 9
• Locations: 0 countries
• Sites: N/A

Brief Summary

The purpose of this study is to examine if a biologically active commercially available amnion chorion membrane (ACM) is as effective as the commercially available inert dense polytetrafluoroethylene membrane (D-PTFE) in preserving jaw bone dimensions and whether it provides the added benefit of reducing post-operative discomfort after dental surgery

Conditions

Alveolar Bone Loss; Pathological Conditions, Anatomical

Keywords

Alveolar Ridge Augmentation; Tooth Socket; Guided Tissue Regeneration; Membranes

Outcome Measures

Primary Outcomes (6)

• Amount of Preservation of Alveolar Ridge Dimensions i.e..,Clinical Horizontal Ridge Width Change in Millimeter as Result of Ridge Preservation Procedures

  A radiographic stent will be fabricated with reproducible access holes ≈5 mm apical to the mid-facial and mid-lingual gingival margin of the teeth to be extracted. On day of surgery, a calibrated examiner masked to treatment allocation, will record initial clinical bucco-lingual (iCBL) ridge measurements in millimeters (mm), through the access holes in the stent, using calipers. Approximately 3.5(±0.5)-months post extractions, the calibrated examiner masked to treatment allocation, will record the final clinical bucco-lingual (fCBL) ridge measurements in mm using the calipers as described earlier. The difference between fCBL and iCBL will be calculated as change in clinical horizontal ridge width dimensions in mm (cΔHD).

  3-4 months

• Evaluation of Preservation of Ridge Quality Through Microtomographic Analysis for Microarchitectural Parameters Expressed as Percentages.

  Approximately 3-months post extractions, a 2.5x10mm core of bone will be removed from the center of the residual ridge using a 2.5mm inner-diameter trephine bur. Cores will be immediately placed into 10%-formalin. A high-resolution microtomographic scanner will be used and images will be scanned at a voxel size of 8µm3. Moist bone cores will be wrapped in paraffin and scanned in air. Cores will be rotated in 0.7 degree increments with 450milli second time exposition. A 0.5m aluminum filter will be used to remove image noise. After scanning, 3D microstructural image data will be reconstructed using software. Structural indices will be calculated using a software. The micro-architectural variables; bone volume density (BV/TV), and bone surface density (BS/BV); will be quantified and reported as percentages.

  3-4 month

• Evaluation of Preservation of Ridge Quality Through Histological Analysis for Microarchitectural Parameters Expressed as Percentages.

  Approximately 3.5(±0.5)-months post extractions, a 2.5x10mm core of bone will be removed from the center of the residual ridge using a 2.5mm inner-diameter trephine bur. Cores will be immediately placed into 10%-formalin. Cores will be process and embedded in polymethylmethacrylate and sectioned to 5μm thickness and sections will be stained with Goldener's Trichrome. With the Goldener's trichrome, mineralized bone appears as green or blue regions, osteoid appears orange-red, nuclei appears blue-grey and graft remnants appear grey. Additional differentiation between graft and new bone will be achieved by morphologically assessing each sample individually. A slide scanner will be used to image the sample (20x magnification), and a software program will be used for the histomorphometric analysis, to quantify the amount of total mineralized bone, new bone / osteoid, soft tissue, and residual graft remnants in percentages .

  3-4 months

• Post Operative Pain

  A visual Analog score (VAS) pain scale form (scale of 1 to 10) will be provided with instructions to record pain levels on both surgical sites every day for 2-weeks post-surgery. VAS score of 10 indicates highest level of pain and 0 indicates no pain. Subjects will also asked to log any pain medications taken in that 2-week period. Subjects will be seen at 1\&2 weeks for post-operative evaluation and VAS forms will be collected. Data will be reported as Average VAS score.

  0-2 weeks

• Amount of Preservation of Alveolar Ridge Dimensions Following Ridge Preservation Procedures i.e., Horizontal Ridge Width Height Change in Millimeters as Assessed Through Analysis of CBCT Scans.

  Radiographic stent with radiopaque reference plane (RRP) will be used to obtain pre-extraction CBCT scans. Approximately 3-months post extractions, a second CBCT will be taken. Radiographic Analyses will be done using radiographic image analysis software by a calibrated examiner. The initial relative crest (iRC) reference point will be determined. The buccal and lingual crests at the central plane of site will be marked and distances from this crest to RRP will be measured in mm. The average distance of the buccal crest height and the lingual crest height will be calculated and that value will be used to determine the iRC for that site. Initial Bucco-lingual (iRBL) measurements will be recorded at 1 mm, 3 mm and 7 mm from iRC in all five planes. The final bucco-lingual (fRBL) measurements will be recorded on the second CBCT, using the same method as described before and using the iRC reference. Differences between iRBL and the fRBL reflect change in horizontal ridge width (RΔHD).

  3-4 months

• Amount of Preservation of Alveolar Ridge Dimensions Following Ridge Preservation Procedures i.e., Vertical Ridge Height Change in Millimeters as Assessed Through Analysis of CBCT Scans.

  Radiographic stent with a radiopaque reference plane (RRP) will be used to obtain pre-extraction CBCT scans. Approximately 3.5(±0.5)-months post extractions, a second CBCT will be taken. Radiographic Analyses will be done using radiographic image analysis software by a calibrated examiner. Initial relative crest iRC will be determined as described above from the initial CBCT. In the second CBCT, vertical distance from the iRC from initial CBCT will be used to recreate the iRC. New relative crest will be determined for each of the three planes (nRC) as above. The difference between iRC and nRC indicates change in vertical dimension at each plane (RΔVD) i.e., iRC - nRC = (RΔVD). Positive (RΔVD) values indicate relative loss of crestal bone height and negative (RΔVD) values indicate relative gain of crestal bone height.

  3-4 months

Study Arms (2)

Amnion chorion membrane

EXPERIMENTAL

Amnion chorion membrane will be placed over bone graft after socket preservation on randomly assigned side of the mouth i.e., contra-lateral to the active comparator.

Device: Placing Amnion chorion membrane over grafted site

d-PTFE membrane

ACTIVE COMPARATOR

dense polytetrafluoroethylene membrane will be placed over bone graft after socket preservation on randomly assigned side of the mouth i.e., contra-lateral to the Experimental side

Device: Placing d-PTFE membrane over grafted site

Interventions

Placing Amnion chorion membrane over grafted site DEVICE

Selected teeth were extracted with minimal trauma to hard and soft tissues. The extraction sites were evaluated to verify presence of intact socket walls. Sockets were thoroughly debrided and a combination of demineralized freeze-dried bone and mineralized freeze-dried bone allograft from a single lot number (Maxxeus, Ohio, U.S.A) was placed in the sockets. Per randomization protocol ACM (BioXclude, Snoasis Medical, Colorado, U.S.A were tucked into the buccal and lingual flaps, which were minimally elevated (2-3mm) and d-PTFE sutures (Osteogenics Medical, Texas, U.S.A) were used to keep membrane in place. Primary closure was not attempted and membranes were intentionally left exposed

Also known as: BioXclude

Amnion chorion membrane

Placing d-PTFE membrane over grafted site DEVICE

Selected teeth were extracted with minimal trauma to hard and soft tissues. The extraction sites were evaluated to verify presence of intact socket walls. Sockets were thoroughly debrided and a combination of demineralized freeze-dried bone and mineralized freeze-dried bone allograft from a single lot number (Maxxeus, Ohio, U.S.A) was placed in the sockets. Per randomization protocol d-PTFE membranes (Cytoplast, Osteogenics Medical, Texas, U.S.A) were tucked into the buccal and lingual flaps, which were minimally elevated (2-3mm) and d-PTFE sutures (Osteogenics Medical, Texas, U.S.A) were used to keep membrane in place. Primary closure was not attempted and membranes were intentionally left exposed

Also known as: Cytoplast

d-PTFE membrane

Eligibility Criteria

• Age: 18 Years - 75 Years
• Sex: all
• Healthy Volunteers: Yes
• Age Groups: Adult (18-64), Older Adult (65+)

You may qualify if:

• Subjects needing bilateral non-molar dental extractions in the same arch and consenting to a 2nd surgery for core-biopsy participated in the study. Subjects were required to be within the American Academy of Anesthesiologists (ASA) classifications ASA I or ASA II. Males between 18-75 years and females between 18-50 years of age were screened.

You may not qualify if:

• inability or anticipated failure to maintain adequate oral hygiene; evidence of active periodontitis; pregnant or breastfeeding mothers, unstable systemic diseases or with compromised immune system (e.g., uncontrolled diabetes, etc.) or unstable bleeding disorders; active infectious diseases (e.g., hepatitis, tuberculosis, HIV, etc.); mental disabilities that may hinder participation; active immunosuppressive therapy, cancer therapy and/or radiation to the oral cavity within last 6-months; conditions/medications contraindicated for bone regeneration (e.g., methotrexate, steroids, bisphosphonates, cyclosporin-A), and and self-reported tobacco usage (equivalent to \>20 cigarettes per day).

Sponsors & Collaborators

• Indiana University: lead
• Snoasis Medical Products: collaborator

MeSH Terms

Conditions

Alveolar Bone Loss; Pathological Conditions, Anatomical

Condition Hierarchy (Ancestors)

Bone Resorption; Bone Diseases; Musculoskeletal Diseases; Periodontal Atrophy; Periodontal Diseases; Mouth Diseases; Stomatognathic Diseases; Pathological Conditions, Signs and Symptoms

Limitations and Caveats

Small Sample size, but expanding study not justified through post hoc analysis. Crossover effects due to split mouth study design potentially indirect and possibly only minimal due to biological infeasibility of cross over effects.

Results Point of Contact

• Title: Dr. Sivaraman Prakasam
• Organization: Oregon Health & Sciences University

prakasam@ohsu.edu

503-346-4711

Study Officials

• Sivaraman Prakasam, BDS., MSD., PhD

  Oregon Health & Science University & Indiana University

  PRINCIPAL INVESTIGATOR

Publication Agreements

• PI is Sponsor Employee: No
• Restrictive Agreement: No

Study Design

• Study Type: interventional
• Phase: phase 2
• Allocation: RANDOMIZED
• Masking: SINGLE
• Who Masked: OUTCOMES ASSESSOR
• Purpose: TREATMENT
• Intervention Model: PARALLEL
• Sponsor Type: OTHER
• Responsible Party: PRINCIPAL INVESTIGATOR
• PI Title: Assistant Professor

Study Record Dates

• First Submitted: November 8, 2015
• First Posted: November 11, 2015
• Study Start: September 1, 2012
• Primary Completion: July 1, 2014
• Study Completion: December 1, 2014
• Last Updated: October 7, 2016
• Results First Posted: October 7, 2016

Record last verified: 2016-08